Braucht noch jemand tickets für den #37c3? Könnte bis zu 3 vermitteln. First come first serve.
coon retweeted
A lot had happened since our last tweet!
names_are_hard just shared pre-alpha build of Magic Lantern for EOS 200D. It lacks most of the features, but it is an important milestone to support new camera generations.
magiclantern.fm/forum/index.…
coon retweeted
Just yesterday this was a very broken 7D after a failed firmware downgrade. Today it works again thanks to collaborative effort on Magic Lantern Discord channel!
More on this story in UART thread: magiclantern.fm/forum/index.…
#magiclantern
@autoexec_bin
coon retweeted
Countless hours spent on adjusting QEMU. Then additional 60h on looking why it crashes on hardware.
#magiclantern @autoexec_bin #EOSR5
magiclantern.fm/forum/index.…
Just in case you have already asked yourself if a Canon RP is able to run Doom... The answer is yes, it can.
I'm proud to announce that I've managed to do my first Doom port ever this week. Thanks to @_kitor @turtius and names_are_hard for help!
youtube.com/watch?v=zytIWGzp…
Just got a defective Speedlite 430-EX II flash on Ebay for 8,50€. It basically works but the flash doesn't flash. If I am lucky it works again if I replace the xenon tube.
... so lets get closer. And yes, the broken glass and the burning mark on the bottom side tell me that this tube is gone. I'll order a new tube and try repair it. When it arrives the cap should be discharged and I can dig deeper.
Canon cameras have an internal counter on how many times the shutter was actuated. It's like the odometer on a car. Turns out RP firmware has a bug which leads into a super huge number here. It seems to be a static offset value of 1086947309 so I have taken 2107 photos until now.
Now where a minimal version of Magic Lantern runs on EOS RP, it's time for some experiments. Models like R, R6 or R5 allow closing the shutter when the camera is turned off. Unfortunately this is not available on RP but thanks to Magic Lantern it will be possible in future. :)
A while ago the foot door opening mechanics of my trashcan broke, so I had to open it by hand. Yesterday I have decided to design and 3D print a simple replacement joint. To my surprise it already works perfectly. 3D printers are awsome!
coon retweeted
Due to coronavirus pandemic, all weddings are doomed anyway. To make your camera useful in such an extreme environment, Turtius ported Chocolate Doom on the EOS 200D/SL2!
reddit.com/r/itrunsdoom/comm…



















