Gaming peripheral reviewer on YT | @AIMERZHQ https://xitter.cf/t.co/G1ZD6rN5Gk | Email: [email protected]
Finland
Joined April 2013
- Tweets2.1K
- Following426
- Followers1.4K
- Likes1K
PSA: If you don't like the slippery scroll wheel of the ATK Phantom, you can swap it with a wheel from the F1 lineup. Here I'm using the F1 V2 ultimate wheel and it was a drop-in replacement that made scrolling ten times better.
jerrorr+ retweeted
🚨 GIVEAWAY ALERT !!🚨
We have a TenZ 2.0 Signature – Misty Blue Medium and we’ve decided to give it away.🤷
➜ Follow @wearemaxgaming
➜ Follow @PulsarGears
➜ Repost this post
🇪🇺 EU ONLY
Oh, and we didn’t stop there.
There’s a Black TenZ 2.0 Signature MINI giveaway going on in our Discord too!👀
Our Discord is where the real peripheral nerding happens: setups, mice, keyboards, mousepads, new releases, recommendations, giveaways and probably way too much discussion about mouse shapes.
Join our discord here: discord.com/invite/maxgaming
Winners will be drawn in a week, GLHF! 🎯
Super glad that premature release gets addressed. Definitely a problem that does not get talked enough 👍
SLX FIRMWARE V1.1.0
A major update to TMR-DS, bringing improved actuation accuracy, finer adjustment, and new controls for release behavior and Smart Rapid Trigger sensitivity.
CHOOSE YOUR RELEASE POINT
A new toggle lets you select between Normal and Early release:
• Normal — the new default.
Releases at the physical release point of the switch. This addresses premature releases experienced by some users with certain grips, including interrupted sprays during sustained clicks.
• Early — the previous behavior.
Releases before the switch’s physical release point, allowing an earlier actuation reset for rapid one taps and consecutive clicks. If you preferred the previous release behavior, select Early.
REBUILT ACTUATION ADJUSTMENT
We overhauled the accuracy and range of the actuation adjustment, introducing finer increments and more selectable actuation points throughout the recommended (green) range.
Your existing actuation setting is automatically mapped to the new slider. Its position may shift by a few ticks as it moves to the new scale, so check your setting after updating and fine-tune it if needed.
ADJUSTABLE SMART RAPID TRIGGER SENSITIVITY
You can now tune Rapid Trigger sensitivity from 150–250 μm.
• Lower values respond to smaller movements.
• Higher values require more movement to trigger a reset or subsequent actuation.
The new default is 220 μm. The previous fixed setting was 190 μm—select 190 μm if you prefer that sensitivity.
PREFER THE PREVIOUS SETTINGS?
Select Early Release and set Rapid Trigger sensitivity to 190 μm.
After updating, review your TMR-DS settings in XPanel.
