Epec, LLC (@epectec) header
Epec, LLC (@epectec) profile picture

Epec Engineered Technologies designs and manufactures custom, build-to-print products for all sectors of the #electronics industry.

New Bedford, MA 02745
Joined September 2010
View our article: EMC and ESD Protection for Human-Machine Interfaces hubs.li/Q04FPP-s0
12
Check pack voltage before allowing significant charge current. hubs.li/Q04FPFgd0
26
Hatched copper planes can improve flexibility, reduce stress concentrations, and help minimize delamination risks. hubs.li/Q04F98bS0
49
View our blog post: Preventing Battery Failures: The 7-Step Charging System Protocol hubs.li/Q04FxzsB0
34
Distinguish warm-up power from holding power. A heater sized to reach temperature quickly may require substantially less average power once the assembly reaches its setpoint. The control system must accommodate both conditions. hubs.li/Q04F91q60
24
See wire extrusion in action during custom cable harness manufacturing. This step produces jacketed wire used in later cable and wire harness assembly. #WireHarness #Manufacturing hubs.li/Q04F75vp0
1
34
Many thermal expansion problems can be prevented by following established rigid-flex PCB design practices before the board reaches fabrication. hubs.li/Q04F7cNg0
39
In some applications, uniform watt density is appropriate. In others, the heater may require multiple heat zones with variable power densities so that additional power is directed toward areas experiencing greater heat loss. hubs.li/Q04DkGnC0
86
View our blog post: Thermal Expansion Challenges in Mixed-Material Rigid-Flex hubs.li/Q04F6XK00
36
To everyone who has worn the uniform of the U.S. Armed Forces, thank you for your service. We honor you today. #VeteransDay
24
If the materials within a flex or rigid-flex design expand at significantly different rates, stress begins to build at the interfaces between them. hubs.li/Q04DPkxv0
23
UN38.3 testing applies to all primary and secondary lithium batteries. hubs.li/Q04DkCk10
39