@copperkitapp

Make your own PCB's with CopperKit's unique scratch milling technique. https://xitter.cf/t.co/GW5UJZEg9p

Joined August 2026
  • Tweets10
  • Following89
  • Followers118
3Media
Make PCB's with a desktop CNC, fast, clean and easy!
1
4
486
Here is a full run of all the steps in a 'hello world' 555 board. youtube.com/playlist?list=PL…

CopperKit

Make Your Own PCBs with CopperKit

youtube.com
2
4
396
Make your own PCBs, right on your bench. 🦊 Fast turnaround, no chemical etching, no smell, no dust - just an idea turning into a working circuit. Watch the process below, then join the CopperKit beta below 👇
2
1
8
213
Join the CopperKit beta here: copperkit.app/#beta

CopperKit - PCB creation for desktop CNC

Make PCBs with micro end mills, V-bits, or stationary scribers on desktop CNC machines of every level.

copperkit.app
28
CopperKit retweeted
stenbjørne@stenbjoerneAug 27
Created a small cap for my er11 collet that has sponge sandpaper glued on that extends 1-2mm further than the Carbide nozzle, so i can scribe and then sand/cleanup without any manual step of tool change 😎 @copperkitapp
1
2
1
5
1,129
My autorouter works! This board completes in around 1 min, and manages to implement the required routing on just 2 layers instead of 4. For comparison: Freerouting was unable to complete the board after 25mins, and I'm tied with DeepPCB on their benchmarks for routing airwires but with half the number of required vias
27
35
5
540
27,425
Running CopperKit on @OmarchyLinux - the little CNC is scratching out a PCB!
2
2
1
8
485
Load more