Getting ready for @JOTAJOTI 2024 from Scouting St. Willibrordus in Beek en Donk, the Netherlands, JO21TM. We will be QRV on 2m and possibly #QO100 next weekend as PA3RVG/J. @jotajoti_nl
72
I converted my QO-100 setup to use an external 12 volt supply instead of PoE so I can power it with a battery and use it portable in the upcoming @JOTAJOTI weekend. I plan to operate from two local scouting groups on saturday. I will test the complete setup on QO-100 tonight.
Very interesting read on how and why ChatGPT (and friends) work. writings.stephenwolfram.com/…
111
Rico van Genugten retweeted
Wondered about where #Artemis1's antenna(s) are?
Wonder no more. There are four equally spaced around the capsule.
Learn More 🧵⬇️
Rico van Genugten retweeted
#Artemis1 uses CCSDS AOS (v2) frames, spacecraft ID is 0x14 and this matches SANA registry: sanaregistry.org/r/spacecraf…
This confirms the signal on 2216.5MHz is really coming from #Artemis1.
Fill frames are sent on VC 63 filled with counting up bytes (no ASCII messages this time☹️).
The scouts of Scouting Beek en Donk built a nice tower for the upcoming @JOTAJOTI weekend. The VHF antenna is mounted to the mast which will be hoisted and mounted out of the top of the tower to about 23 meter AGL. Listen for PA3RVG/J in JO21TM on 2m this weekend! @jotajoti_nl
I might also bring a transceiver and antenna for HF and/or my QO-100 station. I wonder if there is any activity on QO-100 during @JOTAJOTI though.
3
I finalised my Rancilio Silvia upgrade project today. The external prototype control box is gone, everything is integrated in the machine now. It features a better thermostat, temp display on a small OLED display and via MQTT, shot timer, etc. Quite happy with how it turned out.
Next step in improving my Rancilio Silvia: I've put the OLED screen in a small 3D printed casing on the front of the machine and implemented simple on/off control using a relay switching the heater. Overshoot is about 10 deg, about 15 deg less than with the original thermostat.
1
4
I have a Rancilio Silvia espresso machine, known for its good build and bad thermostat. As a first step towards better temp control it I installed a thermocouple connected to an ESP8266 board publishing the measurements using MQTT. The temp swing is about 25 deg. 1/2
3
5
The next step will be controlling the temperature by switching the heater, integrating the board into the machine and exposing the OLED screen on the front. I'm starting off with on/off control with hysteresis, if overshoot turns out too big I can always go for PID later. 2/2
3
Rico van Genugten retweeted
You can listen for updates on the Russia-Ukraine war on BBC World Service live online 📱 bbcworldservice.com
And the map shows our shortwave radio reach in #Ukraine
📻 15735 kHz 16:00 – 18:00 GMT +2
📻 5875 kHz 22:00 – 00:00 GMT +2
Just received this HRPT image from NOAA-18. Some missed lines because tracking is better left to an antenna rotator, but the signal was good enough.
Built a simple weather station using an ESP8266, a BME280 sensor board, an 18650 cell with TP4056 charger board and a small solar panel. Enclosure from thingiverse, printed by a friend. Custom software to squeeze as much battery life as possible out of it. Measures every 10 min.

























