Nick Rich

@CDeklotz 2500 acres on 12 rows. Pretty good for rock points. Designed with a lot of wear material to burn off.

The reality of 3D printing. You’ll probably have to work on your printer at some point. This is true of the 5 different models I’ve owned since 2020. My 7 Bambu X1E printers have printed 1000s of parts for me so I can’t complain.

Last y drop field 🤞

About time to pull the drops off.

One more fill for the day.

Flex Dropping as the storm rolls in.

Flex Drop check.

Nicest field yet.

Dropping the N.

AMS Enlist MSO.

Evening chores.

Not terrible.

132 ft of drops for 22” corn. 👌

Some more Flex Drop parts ready to deliver tomorrow.

The challenges of 3d printing nylon filaments. The print on the right is junk due to moisture in the filament. Foggy and rougher texture from the moisture. This will also make the part brittle. Filament dryer died after I started the print. When everything is dialed in these carbon fiber nylon parts are amazing.

Liberty/Enlist see and spray prepping. Back to the old days of using the AIXR.

Looking ok. 👍

Selling my ZML toolbar. Never been used. Was going to build a 12 row 3pt strip till rig but went a different direction. Nice bar. DM me if interested.

Almost drop season!

Another good day on the fall strips!

I wouldn’t mind having another week of these conditions. Epic strips.